化脓隐秘杆菌对奶牛脾脏组织细胞凋亡的影响

目的观察化脓隐秘杆菌自然感染奶牛脾脏组织的病理学变化,并检测组织细胞中Caspase-3、Caspase-8、Caspase-9、Bax和Bcl-2的表达,以确定化脓隐秘杆菌感染对奶牛脾脏组织细胞凋亡的影响。方法筛检2头化脓隐秘杆菌阴性健康奶牛(对照)和5头自然感染化脓隐秘杆菌的奶牛,收集脾脏组织样本,采用本课题组国家发明专利方法,进行石蜡制片和HE染色,观察脾脏组织病理学变化;采用免疫组织化学方法与本课题组国家发明专利方法相结合,检测奶牛脾脏组织中与细胞正负凋亡相关的调节基因Bax和Bcl-2及凋亡通路蛋白Caspase-3、Caspase-8和Caspase-9的表达情况。结果肉眼观察可见化脓隐秘杆菌自然感染奶牛脾脏肿大、柔软,有出血;病理组织学观察可见脾脏组织出血,水肿,淋巴细胞数量减少,有坏死;脾脏淋巴细胞Caspase-3、Caspase-9和Bax表达阳性,与对照组相比,差异有统计学意义(P <0.05),少量淋巴细胞Caspase-8和Bcl-2表达阳性,与对照组相比,差异无统计学意义(P> 0.05)。结论化脓隐秘杆菌能够引起奶牛脾脏淋巴细胞发生坏死和凋亡;可通过调节脾脏中淋巴细胞Bcl-2家族的活性,引起其Bax和Bcl-2比率改变,增加淋巴细胞线粒体内外膜通透性,导致与凋亡相关因子的释放,激活Caspase-9,进一步激活Caspase-3,从而引起脾脏中淋巴细胞发生凋亡。     

Comparison between fluctuation of floating potential gradient and velocity of blob structure on HL-2A tokamak

Several results based on the Langmuir probes' data on the HL-2A tokamak are presented. The blob structures' radial and poloidal drift velocities, estimated by the gradient of floating potential and by time delay evaluation, are compared in different line-averaged density and electron cyclotron resonance heating conditions. A positive correlation is observed in the comparison between blobs' radial velocity estimated by the two methods mentioned above, regardless of the situation differences mentioned above. Correlation is also observed in the comparison between the blobs' poloidal velocity estimated by the two methods in different situations, while a shift due to the different line-averaged density is observed. These results imply that the radial gradient of floating potential may have some value as a reference during data analysis in low-parameter discharge.     

软化+微滤膜工艺处理填埋场渗滤液的中试研究

以阜阳市某生活垃圾填埋场渗滤液为研究对象,针对渗滤液高硬度、低碱度的特点,考查软化+微滤膜中试工艺对填埋场总硬度的处理效能,分析微滤膜运行参数对膜通量和产水流量的影响.中试结果表明:软化+微滤膜工艺可有效去除水源中钙镁离子污染问题,控制软化装置的反应池pH在11.5,总硬度(以CaCO3计)的去除率在94％以上,出水总硬度(以CaCO3计)稳定<100 mg/L.软化微滤工艺对渗滤液中COD的平均去除率为16.2％.单支微滤膜正常运行,反洗频率30 min时,可将膜通量恢复至初始通量的90％以上.由中试可知,微滤膜具有良好的抗污染性能,在进膜污泥浓度为4.97 g/L及以上时,初始膜通量仍能保持较高值.     

Simulations of NBI fast ion loss in the presence of toroidal field ripple on EAST

NBI fast ion losses in the presence of the toroidal field ripple on EAST have been investigated by using the orbit code GYCAVA and the NBI code TGCO. The ripple effect was included in the upgraded version of the GYCAVA code. It is found that loss regions of NBI fast ions are mainly on the low field side near the edge in the presence of ripple. For co-current NBIs, the synergy effect of ripple and Coulomb collision on fast ion losses is dominant, and fast trapped ions located on the low field side are easily lost. The ripple well loss and the ripple stochastic loss of fast ions have been identified from the heat loads of co-current NBI fast ions. The ripple stochastic loss and the collisioninduced loss are much larger than the ripple well loss. Heat loads of lost fast ions are mainly localized on the right side of the radio frequency wave antennas from the inside view toward the first wall. For counter-current NBIs, the first orbit loss due to the magnetic drift is the dominant loss channel. In addition, fast ion loss fraction with ripple and collision for each NBI linearly increases with the effective charge number, which is related to the pitch angle scattering effect.     

基于1D CNN与XGBoost的恶意代码纹理检测

恶意代码数量已经呈现爆炸式增长,对于恶意代码的检测防护显得尤为重要.近几年,基于深度学习的恶意代码检测方法开始出现,基于此,提出一种新的检测方法,将恶意代码二进制文件转化为十进制数组,并利用一维卷积神经网络(1 Dimention Convolutional Neural Networks,1D CNN)对数组进行分类和识别.针对代码家族之间数量不平衡的现象,该算法选择在分类预测上表现良好的XGBoost,并对Vision Research Lab中的25个不同恶意软件家族的9458个恶意软件样本进行了实验.实验结果表明,所提的方法分类预测精度达到了97％.     

农药沉积利用率喷雾指示剂诱惑红的酶标仪测定方法

诱惑红是一种水溶性染料,近年来被用作农药沉积利用率测定的指示剂。诱惑红的检测方法为高效液相色谱法和分光光度法。高效液相色谱法需要专门的分析仪器,且价格昂贵,可见分光光度计法操作繁琐,试剂用量大,耗时长,均不适宜田间快速高效测定。笔者发展了诱惑红的酶标仪测定方法,简单高效,可批量检测多个样品,且准确度和精密度高,线性关系良好,514 nm检测波长下不受其他农药影响,并应用于玉米无人飞机喷雾场景下农药雾滴在玉米冠层的沉积利用率测定。     

Effect of phosphogypsum on saline-alkalinity and aggregate stability of bauxite residue

A column experiment was conducted to investigate the effect of phosphogypsum (PG) on the saline- alkalinity, and aggregate stability of bauxite residue. Results showed that: with increasing leaching time, the concentrations of saline-alkali ions decreased while the concentration increased in bauxite residue leachate; compared with CK (control group) treatment, pH, electric conductivity (EC), exchangeable sodium percentage (ESP), sodium absorption ratio (SAR), and exchangeable Na⁺ content of bauxite residue were reduced following PG treatment; average particle sizes in aggregates following CK and PG treatments were determined to be 155 and 193 nm, respectively. SR-μCT test results also confirmed that bauxite residue following PG treatment acquired larger aggregates and larger pore diameter. These results indicate that the PG treatment could significantly modulate the saline-alkalinity, and simultaneously enhance aggregate stability of bauxite residue, which provides a facile approach to reclaim bauxite residue disposal areas.     

Achieving fabrication of highly transparent Y2O3 ceramics via air pre-sintering by deionization treatment of suspension

An easy albeit quite effective deionization suspension treatment was adopted to alleviate the detrimental effects related to the hydrolysis of Y₂O₃ in an aqueous medium. Fabrication of highly transparent Y₂O₃ ceramics with a fine grain size via air pre-sintering and post–hot isostatic pressing (HIP) treatment without using any sintering additive was achieved using the treated suspensions. The hydrolysis issue of Y₂O₃ powder in an aqueous medium was effectively alleviated by using deionization treatment, and a well-dispersed suspension with a low concentration of dissolved Y³⁺ species was obtained. The dispersed suspensions were consolidated by the centrifugal casting method, and the green bodies derived from the suspension of 35.0 vol% solid loading showed an improved homogeneity with a relative density of 52.1%. Fully dense Y₂O₃ transparent ceramic with high transparency was obtained by pre-sintering consolidated green compacts at a low temperature of 1400°C for 16 h in air followed by a post-HIP treatment at 1550°C for 2 h under 200 MPa pressure. The sample had a fine average grain size of 690 nm. The in-line transmittance of the sample reached 83.3% and 81.8% at 1100 nm and 800 nm, respectively, very close to the theoretical values of Y₂O₃.     

Studies on waterline corrosion processes and corrosion product characteristics of carbon steel in 3.5 wt% NaCl solution

The waterline corrosion behaviors of carbon steel partially immersed in a 3.5 wt% NaCl solution were investigated using the wire beam electrode technique, and the effects of corrosion products on the processes of waterline corrosion were analyzed. The results demonstrated that the initial stage and development stage of waterline corrosion were mainly controlled by the concentration and diffusion of dissolved oxygen, respectively, and the deceleration stage of waterline corrosion was mainly affected by corrosion products. The main component of the yellow corrosion products was γ-FeOOH, and γ-FeOOH that exhibited a high reduction reactivity could be involved in the cathodic reaction. The black corrosion products were mainly composed of Fe₃O₄ with strong thermodynamic stability and the processes of dissolved oxygen diffusion and ion transports were obviously affected due to the continuous accumulation of Fe₃O₄ on the surface of the electrodes. Polarity reversals were observed on the single electrodes below the waterline, but the reasons for the phenomena were different from each other.